I am in the process of setting up a virtualized OPNsense firewall on Proxmox on a Thinkcentre 720q. The proxmox host has 3 network interfaces.

  • A dual NIC gigabit card where one interface is for WAN and other for LAN, say eth1 and eth2
  • Another interface which came with the PC itself, say eth3

PS: I also have a switch for all my other devices.

After some research, I have understood that

  1. Passing (pass-through) the NIC to the OPNsense VM is better for performance
  2. Passing it through removes the interface from the host OS
  3. If passing is not done correctly, you may lose access to Proxmox.

My questions are

  1. How do I set eth2 to be the LAN port and also use it connect to proxmox?
  2. If I use point #1 (eth2 for LAN), how much will the throughput of eth2 be affected? (My ISP provides me symmetrical 320 Mbps link speed)
  3. If I use point #1, will local traffic (traffic handled by my switch) be affected?
  4. (Optional/Experimental) Since I have a spare port (eth3), can I use it for special purpose (a dedicated management port which will work even if OPNsense is down)?
  5. If I use point #4, my switch will have two ethernet connections from the proxmox host. Will this cause loops and kill my network?

You can answer this selectively by mentioning the question number.

If you have a better idea regarding how to setup OPNsense on Proxmox, please share.

Edit #1: Thank you for all your responses! It seems I have to study a lot. Let me answer a few questions

  1. I am not managing workloads for a dozen of people with strict SLAs. I’m just doing it for my family and myself.
  2. I understand the point that something as critical as a firewall should have its own hardware. However, I just want to experiment with few VMs on Proxmox. I want to setup Proxmox once and let it be.
  3. I eventually want to get into VLANs but that is not a priority right now. My future plan is to integrate this with some Omada access points.
  4. I’ve added a diagram of what I want to do. Please forgive my crude drawing as it’s the best I can do for now.

Please let me know if you want some more information

Edit #2: Thank you for sharing your experience with Proxmox and OPNsense. I’m still reading and re-reading all of your comments to check if I have missed anything.

I have made a small mistake of not ordering the dual NIC + angled riser card before the host arrived, so my host is currently idle. When it arrives, and I manage to set it up, I will make a new post and share what i’ve learnt.

Thank you again!

  • NarrativeBear@lemmy.worldEnglish
    1·
    21 hours ago

    Lines F and E don’t exists in your diagram, all your VMs inside of Proxmox are accessible and sharing port eth3. Except Opensense, as its not bridged to eth3, but instead is assigned to the NIC card you have.

    OPNSense inside Proxmox is the only VM that will see the NIC card and be the only VM that uses that NIC with those interfaces.

    One interface would be for WAN in like you drew, and the other is the LAN port like on any other router. This LAN port needs to connect to a switch as this is where your OPENsence will communication with the rest of the home network and handout DHCP addresses. It’s also how you would reach your OPENsense GUI through a browser. (Outside of managing it within Proxmoxs GUI, accessible on eth3)

    If your OpenSense VM goes down your home network won’t have a router which means no PCs would be able to communicate as they would have no DHCP addresses, so even if all your communication is “inside of Proxmox” your VM still would not get a DHCP addresses.