Get the batteries out and wipe the electronics with a soft towel soaked with a little vinegar to neutralize the corrosion. Then a damp towel with just water to get the vinegar up. Let it fully dry before putting in new batteries. This happens to batteries that have sat unused for a long time installed. It can also happen if at the end of charge, you pull the batteries out, and put them back in to squeeze a little more use out of the batteries. Do it too many times and there is a leak risk. Cheaper batteries do it more often but the top brands will occasionally leak as well.
Why not just switch to NiMH rechargables? Upfront cost is a bit higher, but considering the 10 or so year lifespan in a TV remote, they make sense. And they don’t leak.
I found an old plush that had a voicebox in it… I’ve not touched it in 25+ years but wanted to show it to my daughter, so I pulled out the battery box, expecting the worse, and there was no corrosion at all. I pulled out the generic brand batteries and put in new batteries and it started speaking.
In the future, someone will have this same story but the ending will be the toy telling you to connect to WiFi and update your subscription information…
I remember hearing that alkaline batteries that contain mercury don’t leak, they’re just much worse for the environment. So maybe that’s what happened?
This is the way. Sometime I even file down the spring/contacts with a nail file to expose fresh metal rather than corrosion. Just a few light scratches helps greatly.
If you have access to one, use an ultrasonic cleaner with vinegar and water in it to clean the parts you can take out (NOT the batteries themselves! Those are done)
CRC is a hydrocarbon based cleaning solution similar to isopropyl alcohol. Vinegar works to clean the alkaline corrosion specifically because it is acidic, so it will both neutralize the alkalinity and also act as a mild etchant.
It is important that you thoroughly clean all of the vinegar, since leaving it on for too long will etch away the copper (though when I say “for too long”, I mean a very long time).
Get the batteries out and wipe the electronics with a soft towel soaked with a little vinegar to neutralize the corrosion. Then a damp towel with just water to get the vinegar up. Let it fully dry before putting in new batteries. This happens to batteries that have sat unused for a long time installed. It can also happen if at the end of charge, you pull the batteries out, and put them back in to squeeze a little more use out of the batteries. Do it too many times and there is a leak risk. Cheaper batteries do it more often but the top brands will occasionally leak as well.
Vinegar here really does the trick in neutralizing the acid. do not skip it!
Vinegar (Acetic Acid) does not neutralise any acids at all.
It does however, neutralise the caustic, alkaline contents of a non-rechargeable alkaline cell (potassium hydroxide).
That just sounded factual.
Acid is just upside-down base
Neutralise the corrosion with a conjugate pair acids/base buffer.
Neutralise was a confusing term to pick, but they’re not wrong.
How the shit? Just use baking soda in water instead.
I believe the comment you are replying to meant to say corrosion not acid.
This is some sort of electrochemistry, more complex than just acid/base
I’m just going to say alkaline batteries have a strong hydroxide so use any acid.
I’m pretty sure its an acid/base conjugate pair buffer, but I could be wrong
Alkaline batteries use a base, hence the name. Baking soda would work as you can neutralize a strong base with a weak one. Same with acid…
Why not just switch to NiMH rechargables? Upfront cost is a bit higher, but considering the 10 or so year lifespan in a TV remote, they make sense. And they don’t leak.
I found an old plush that had a voicebox in it… I’ve not touched it in 25+ years but wanted to show it to my daughter, so I pulled out the battery box, expecting the worse, and there was no corrosion at all. I pulled out the generic brand batteries and put in new batteries and it started speaking.
I was amazed.
In the future, someone will have this same story but the ending will be the toy telling you to connect to WiFi and update your subscription information…
:(
I remember hearing that alkaline batteries that contain mercury don’t leak, they’re just much worse for the environment. So maybe that’s what happened?
deleted by creator
This is the way. Sometime I even file down the spring/contacts with a nail file to expose fresh metal rather than corrosion. Just a few light scratches helps greatly.
If you have access to one, use an ultrasonic cleaner with vinegar and water in it to clean the parts you can take out (NOT the batteries themselves! Those are done)
How does vinegar compare to a can of CRC?
It doesn’t.
CRC is a hydrocarbon based cleaning solution similar to isopropyl alcohol. Vinegar works to clean the alkaline corrosion specifically because it is acidic, so it will both neutralize the alkalinity and also act as a mild etchant.
It is important that you thoroughly clean all of the vinegar, since leaving it on for too long will etch away the copper (though when I say “for too long”, I mean a very long time).
Doesn’t smell as good but tastes a bit better.